News
Code of Practice for Wire Mesh Welding Machine
Date:17-10-13, 06:36 AM
Source:
Author:
1. Rebar mesh wire mesh machine should be installed before the boot, should be removed in the protective cover, protective cover installed, or may endanger personal safety.
2. Do not be in any part of the body or any object close to the touch movement of the body, such as the movement of the net car, the beam, horizontal hopper, clapping body, transmission sprocket, chain, induction body, to avoid injury.
3. Do not touch the power switch after the proximity switch and the cabinet, transformers and other dangerous parts with a dangerous voltage, for testing and debugging, to be professional staff.
4. Do not put your hands between the upper and lower electrodes that are being pressed.
5. Do not plug the wire mesh machine control wiring plug, set off the top of the transformer protection board.
6. Do not remove, break the host and the control cabinet on the ground safety protection line. Regularly check the grounding safety protection line is good.
7. When the fuse box fuse fuse, you should first stop power outage, found by the electric fuse after the fuse, and then the same model specifications of the melt core replacement. Otherwise it will cause a fire and burn the device.
8. Do not arbitrarily adjust the device inside the cabinet. Do not put tools, wire and other debris into the electronic control cabinet or on the top of the machine and pull the rack rack.
9. must be timely on the bearings, sliders, chute, slip sets and other parts of the friction filled with lubricating oil, not lack of oil operation. The filling of the lubricating oil should be carried out after the shutdown.
10. Steel mesh wire mesh machine operator for some reason to leave the net welding machine must be shut down power failure, and the main motor speed control knob to a minimum. Long time to leave
Should turn off the power switch, lock the control cabinet, so as not to misuse the others. And should be so that the upper and lower electrode from the contact, shall not stay in the pressure contact state.
